VOLTCRAFT HPS-11530 - Page 41

41
Select the respective memory slot “P1, P2 or P3” on the rear slider. The respective output voltage is indicated on the
display (2).
Now you can connect and switch on the consumer.
)RUGHDFWLYDWLQJWKH¿[HGYROWDJHIXQFWLRQVOLGHWKH³02'(´VOLGHUEDFNWRWKH³1RUPDO´SRVLWLRQ7KH/('
display “REAR CONTROL” (6) goes out. The device switches back to normal power unit operation (always remove
DC consumers before!)
Assigning memory slots with “Set”
$OOWKUHHPHPRU\VORWVFDQEHDVVLJQHGXVHUVSHFL¿FYDOXHVIRURXWSXWYROWDJHDQGFXUUHQWOLPLWDWLRQ
Make sure that no consumers are connected.
For this purpose, proceed as follows:
Activate the “Set” function through the “MODE” (13) slider on the rear. Put the
switch in the “Set” position. The front LED display “REAR CONTROL” (6) lights up.
Select the respective memory slot “P1, P2 or P3” on the rear “RECALL” (15) slider. The respective values for current
and voltage are indicated on the display (2/3). The front rotary controls (7 and 8) can be used to set the desired
output voltage and current limitation.
If required, repeat these steps with the other memory slots.
:KHQDOOSDUDPHWHUVDUHVHWVOLGHWKH³02'(´VOLGHUEDFNWRWKH³3UHVHW´SRVLWLRQIRU¿[HGYROWDJHRSHUDWLRQRU
to the “Normal” position for standard operation.