What to do if VOLTCRAFT PSP 12010 Laboratory Equipment power supply unit does not accept any entries?
If the VOLTCRAFT Laboratory Equipment power supply unit isn't accepting entries, it might be due to the key lock function being active. Try deactivating the key lock. Alternatively, the device software status may be undefined; in this case, turn the device off and then on again.
Why connected consumers do not function with VOLTCRAFT PSP 12010 Laboratory Equipment?
If connected devices aren't working with the VOLTCRAFT Laboratory Equipment, ensure the correct voltage is set and the polarity is correct. Also, verify that the DC output is activated. It's also recommended to check the technical specifications of the connected devices.
How to troubleshoot VOLTCRAFT PSP 12010 Laboratory Equipment when the mains power supply does not work?
If the VOLTCRAFT Laboratory Equipment mains power supply isn't working, check if the green power indicator is lit. You should also check the mains voltage and inspect the mains fuse in the device or the line circuit breaker.
General| Type | Programmable DC Power Supply |
|---|---|
| Output Voltage | 0 - 120 V |
| Output Current | 0 - 10 A |
| Power Rating | 1200 W |
| Voltage Resolution | 10 mV |
| Current Resolution | 10 mA |
| Cooling | Fan |
| Operating Temperature | 0°C to 40°C |
| Protection Features | Overtemperature |
| Interface | RS-232, USB |
To Next Page
