VOLTCRAFT PSP 12010 - English; Intended Use

19
Table of Contents
Introduction............................................................................................................................................ 18
Intended use.......................................................................................................................................... 19
Operating elements .............................................................................................................................. 20
Commissioning ...................................................................................................................................... 23
General ............................................................................................................................................ 23
Connecting the mains cable ............................................................................................................ 23
Basic operation ................................................................................................................................ 23
Setting the output voltage „UCoarse/U Fine“ .................................................................................. 24
Setting the voltage limitation „Umax“................................................................................................ 24
Setting the current limitation „Imax“.................................................................................................. 25
Setting the capacity limitation „Pmax“ .............................................................................................. 25
Input lock „Keylock“.......................................................................................................................... 25
Connecting a consumer .................................................................................................................. 26
Control via software .............................................................................................................................. 25
Establishing the data connection...................................................................................................... 26
Software installation ........................................................................................................................ 27
Software .......................................................................................................................................... 27
Interface log...................................................................................................................................... 28
Disposal ................................................................................................................................................ 29
Maintenance and cleaning .................................................................................................................... 29
Troubleshooting .................................................................................................................................... 30
Technical data........................................................................................................................................ 31
Intended use
The programmable laboratory power supply unit serves as a potential-free DC voltage source to operate
low-voltage consumers. It is connected via 4mm safety sockets. The voltage and current strength can be
set on the output as follows (depending on the respective model):
PSP 12010 0.1 - 20 V/0 - 10 A
PSP 1405 0.1 - 40 V/0 - 5 A
PSP 1803 0.1 - 80 V/0 - 2.5 A
All parameters are set via a digital rotary dial. The device has an illuminated, 4-line display.
The parameters can be selected via 3 buttons.