32
7. Explanation of symbols and indications
The following symbols and indications are visible on the device or in the display.
Overload indicator; the measuring range was exceeded
Symbol for acoustic continuity test
OFF Switch position “OFF”
COM/- Reference potential, - for DC
+ Measuring potential, + for DC
AC
Alternating voltage and current
DC
Direct voltage and current
Vrms RMS value for AC measurement
Vp-p Peak-to-peak value for AC measurement
mV Millivolt (exp.–3)
V Volt (unit of electric voltage)
A Ampere (unit of electric current),
mA Milliampere (exp.–3)
μA Microampere (exp.–6)
kHz Kilohertz (unit of electric frequency, exp.3)
Ω Ohm (unit of electric resistance)
kΩ Kiloohm (exp.3)
MΩ Megaohm (exp.6)
LI Diode operating current
LV Diode forward voltage
hFE Transistor gain factor
Iceo Transistor open-base collector-to-emitter current
IC Collector current
IB Base current
Power ON Light Power indicator
To Next Page
Loading...
