Operating elements
1 Clamp-on ammeter sensor
2 LED display for non-contact voltage mea-
surement (NCV)
3 Opening lever for clamp-on ammeter sensor
4 Hold key
5 Rotary switch
6 Hz % key
7 MODE key
8 REL key
9 LC display
10 COM measuring socket (reference potential)
11 VΩ capacity measuring socket (for com-
mensurability „+“)
12 Battery compartment (on rear)
13 RANGE key for manual range selection
14 MIN/MAX key to display the smallest and
biggest measurement values
Safety instructions
Please read the entire operating instructions before using the
product for the first time; they contain important information on
the correct operation.
The guarantee is rendered invalid when damage occurs as a
result of non-compliance with the operating instructions! We do
not assume any liability for any damage arising as a conse-
quence!
We do not assume any liability for material and personal damage
caused by improper use or non-compliance with the safety
instructions. Under these circumstances, any warranty expires.
This device left the manufacture’s factory in a safe and perfect condition.
31
To Next Page
Loading...
Need help?
General
