Reverse Gear
Oil level, checking and topping up
1 Start the engine and let it run on idle a few minutes.
2 Remove the dipstick by turning counter-clockwise.
3 Wipe the dipstick and reinsert it in the reverse gear
without screwing it in. Remove the dipstick and
check the oil level. The correct oil level is between
the MAX and MIN markings.
4 Top up the oil as required using the dip stick tube.
Please refer to section Technical Data page 71
for oil quality and capacity.
IMPORTANT!
Never over-fill the reverse gear. The oil level must
always be within the recommended range.
Reverse Gear, Oil Change
1 Pull out the oil dipstick.
2 Pump out the oil with the oil drain pump through the
oil dipstick hole.
3 Measure out the correct quantity of oil and fill
through the oil dipstick hole. For oil grade and quan-
tity, refer to the Technical Data page 71 section.
4 Put the oil dipstick back in place.
IMPORTANT!
Never over-fill the reverse gear. The oil level must
always be within the recommended range.
Maintenance
47702088 05-2011 57
47702088 - Downloaded from www.volvopenta.com 02/06/2011 18:54:55
To Next Page
Loading...
