Replacement of anodes
1 Remove the anode retaining screws.
2 Clean the contact surface.
3 Install the new anodes and tighten them so that they
make good contact with the underlying metal.
Drive Unit Bellows
WARNING!
Secure the drive unit in a raised position in such a way
that it cannot fall when working on the drive bellows. A
falling drive may cause serious injury.
•
Check that there are no splits or damage to the bel-
lows. Replace bellows as necessary.
Keep the surfaces clean; fouling on the bellows may
puncture them.
•
Inspect the inside of the bellows for signs of contact
with the universal joint when the drive is removed.
Internal wear is a sign that the engine has be run at
too high rpm with the sterndrive in an inclined posi-
tion.
•
Check that the clamps are correctly installed.
Maintenance
47705992 05-2015 © AB VOLVO PENTA 109
To Next Page
Loading...
