Replacing drive belts
1 Remove the protective cover (accessory) over the
drive belts, where fitted.
2 Turn the belt tensioner (1) out of the way and
remove the drive belt.
The belt tensioner can be locked in its bottom posi-
tion with the aid of a screwdriver to facilitate belt
replacement.
Repeat the procedure with the other belt (2).
3 Install the new drive belts.
4 Check that the drive belts are positioned correctly
in the grooves.
5 Replace the protective cover (accessory) over the
drive belts.
Checking exhaust line
The exhaust line must be checked annually for corro-
sion between the hose and the pipe.
WARNING!
Risk of water entry. The exhaust line must be inspected
while the boat is on land. In case of serious corrosion
damage, the pipe must be repaired or replaced with a
new one.
1 Undo the hose clamps and remove the bellows.
2 Check the contact surface. The pipe must be
repaired or replaced if there is serious corrosion
damage.
Maintenance
47705992 05-2015 © AB VOLVO PENTA 85
To Next Page
Loading...
