Station Panel
Activation
Activate the
helm station with a single press of the but-
ton.
Further pressure locks the helm station.
To render the helm station inactive, hold the button
down for 3 seconds.
Inactive helm station
Active helm station
Locked helm station
Low speed and Power Trim Assistant (PTA)
Depending on the installation the optional functions
lowspeed or Power Trim Assistant are engaged with
the button.
Low speed
For further information about the function, refer to
Optional page 42.
Power Trim Assistant (PTA)
For further information about the function, refer to
Instruments and Controls page
31
.
Neutral button
The gearshift
function can be disconnected so that the
control lever only operates the throttle. The neutral
button disengages the drive/reverse gear so that
engine speed may be increased without driving the
boat; (warm-up mode).
The drive is disengaged.
Drive engaged for movement ahead/astern.
Single lever
When the single-lever function is activated, the lever
that is
moved from its position first becomes the control
lever for both engines. The other control lever has no
function as long as the single-lever function is acti-
vated.
In order to activate the single-lever function, the control
levers must in be roughly the same position, max 10%
difference.
Instruments and Controls
47702599 12-2011 13
47702599 - Downloaded from www.volvopenta.com 23/11/2015 22:01:35
To Next Page
Loading...
