Engine Oil, Change
Always follow the recommended oil change interval.
Use an oil drain pump (optional) to pump the oil out of
the oil pan.
1 Run the engine until warm so that the oil is easier
to pump. Then stop the engine.
Wait 15 minutes to allow the oil time to reach the
sump.
WARNING!
Hot oil and hot surfaces can cause burns.
2 Connect a suitable hose to the drain pump
discharge (1) and lead it to a collection vessel.
3 Open the tap (2) under the drain pump to the
position for draining engine oil (E).
4 Replace the oil filter and by-pass filter at every oil
change. Refer to Oil filter, Change, page 45.
5 Close the tap (S). Refill with new oil to the correct
level. For engine oil quantity, refer to Oil level,
checking and topping up, page 43.
IMPORTANT! Only use a recommended grade of
oil.
6 Start the engine and let it idle. Check the oil
pressure. Check that no leaks are present at the
filters.
WARNING!
Working with or approaching a running engine is a
safety risk. Watch out for rotating components and
hot surfaces.
7 Stop the engine. Wait 15 minutes before checking
the oil level. Top up as needed.
Hand in the old oil and filters to a recycling station.
Maintenance
44 47713336 03-2021 © AB VOLVO PENTA
To Next Page
Loading...
