EasyManuals Logo

Volvo Penta DPX 500 User Manual

Volvo Penta DPX 500
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
26
If you do not move the remote control handle to
IDLE
as soon as the engine starts, the engine will overspeed
and could be damaged.
When you start your engine for the first time after off-season storage, always run the engine in
IDLE
for one
minute to allow the water pump to prime.
Starting the engine (warm start) _________________________________________________
1. Move the control handle to the
NEUTRAL
detent position.
2. Turn the key switch to
START
and hold until the engine starts, but for no longer than 10 seconds. If the engine
does not start, let go momentarily, then try again.
3. As soon as the engine starts, release the key to
ON
or
RUN.
Never leave the key in the ON position with the engine not running. This could damage the engine. Never turn
the key to START when the engine is running. This could damage the engine.
If the engine floods:
Advance the control handle to 100% throttle to clear a flooded engine. In this throttle position, with the engine speed
below 400 RPM (cranking speed), the ECM turns off the fuel injectors so no fuel is delivered. When the throttle
position is moved from full throttle, the ECM returns to the starting mode.
Be prepared to quickly move the control handle to IDLE once the engine starts. This will avoid speeding and possibly
damaging the engine.
Immediately after engine start-up, look at all instruments. If any readings are abnormal, stop the engine and
determine the cause.
Stopping the engine ___________________________________________________________
1. Move the remote control handle to NEUTRAL.
2. Turn ignition key to OFF.
Do not stop the engine at speeds above idle or “speed up” the engine while turning off the ignition. Engine
damage could result.
Steering system operation ______________________________________________________
The DPX drive unit features the Volvo Penta Xact™ control steering. This system features an integrated, external
hydraulic power steering system as standard equipment. The external steering cylinders connect directly to the
sterndrive(s) without intermediate steering arms or joints. This results in exact steering capability with 2.7 steering
wheel turns between the end positions.
If the power steering system stops operating, it will feel harder to steer. If this condition occurs, look for
possible causes and fix them if possible. If the power steering system cannot be corrected on board, proceed
at a reduced speed. (You will be able to steer the boat, but with increased effort.) See your Volvo Penta dealer
as soon as possible to correct your power steering system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volvo Penta DPX 500 and is the answer not in the manual?

Volvo Penta DPX 500 Specifications

General IconGeneral
BrandVolvo Penta
ModelDPX 500
CategoryEngine
LanguageEnglish

Related product manuals