Switches
Activate fire suppression
system, see page 85
Switches in the electrical center
Door brake
The door brake switch in the electrical
center is similar to the emergency
switch. This two position toggle switch is
used to activate or deactivate the door
brake function.
• When the switch is in the up position,
the door brake is activated.
• When the switch is in the down
position, the door brake is
deactivated.
Door brake
Air condition test switch
The switch can be used to test if the air
conditioning is working.
A/C gas charging
MCM service switch
To allow for updates or programming of
the Master Control Module (MCM),
ativate the below switch. When the
switch is activated, it is not possible to
start the bus.
MCM service switch
04
Instruments and controls
49
To Next Page
Loading...
