Toilet
NOTE
Regular wholesale toilet paper is not
recommended since it can block the
system.
Valves
Use the valves to fill and drain the tanks.
The fill valves for the water tanks are
located on the right side of the bus,
above the front axle. The drain valves
are located under the passenger area in
front of the rear axle.
1 Fill valve, water tank for sink
2 Drain valve, water tank for toilet
3 Sewage tank
4 Fresh water tank
5 Drain valve, fresh water tank
6 Pumps
Tanks
NOTE
If any of the tanks are full or empty, the
driver is notified by a warning in the driver
information display
The toilet is equipped with one water
tank (for flushing and hand washing) and
a sewage tank.
Empty the sewage tank:
When the sewage tank is full, a red light
in the dashboard alerts the driver. Follow
these steps:
1 Position the bus so that the drain
valve outlet is above the indicated
place for sewage discharge content.
2 Open the tank drain valve, using the
button placed behind the mirror in the
toilet. A green warning is illuminated
while the valve is open.
3 Empty the tank.
4 Close the valve by pressing the
button again.
Empty the water tank:
Empty the water tank if the ambient
temperature risks falling below 0°C.
05
Equipment
79
To Next Page
Loading...
