Maintenance service, every 500
hours
Radiator and coolers, cleaning
WARNING
Risk of burns!
Hot machine parts could cause burns.
Allow hot machine parts to cool before performing
adjustments or service. Wear personal protective
equipment.
Remove the panel on the right hand side of the
machine to access the radiator/hydraulic oil cooler
unit as follows:
1 Remove the screws of the panel.
2 Pull the upper area of panel and remove it.
3 Reinstall the panel after the service is done.
Clean radiator/hydraulic oil cooler unit (1) with
compressed air from inside the engine
compartment (through the fan) to outside.
NOTICE
Preferably only clean the radiator fins with
compressed air! Only clean the engine with water,
when it is cold!
Primary air filter, cleaning and
replacing
Air filter, cleaning
NOTE!
Avoid damaging or denting of the front face of the
filter.
Never clean the filter by knocking it against a hard
object.
Clean the primary filter as needed.
To Next Page
Loading...
