Mirror and camera (if installed) settings
Mirrors, adjusting
ISO 5006 states that an imaginary boundary line
around the machine must be visible to the operator.
Park the machine straight and on level ground.
Adjust the mirrors until the imaginary boundary
line is visible to the operator, see figure below.
NOTE!
Camera may be also used to create visibility on the
rectangular boundary. (Camera is not adjustable on
the machine.)
Close-up visibility boundary according to ISO 5006 (thick line)
A Refer to the table below*
B 1.0 m (39.4 in)
C 1.0 m (39.4 in)
D 1.0 m (39.4 in)
Test object height/Region of the rectangular boundary (A)*
Front side Left side Right side Rear side
1.0 m (39.4 in) 1.0 m (39.4 in) 1.2 m (47.2 in) 1.0 m (39.4 in)
Operating instructions
139
To Next Page
Loading...
