5 Connect the batteries of the machine by turning
on the battery disconnect switch.
6 Start the engine with the ignition switch in a cab.
7 Leave the batteries connected for 5-10 minutes
after starting the engine.
8 Disconnect the jump lead from the chassis
connection on the machine, and then disconnect
the other end of the jump lead from the (-)
terminal on the booster battery.
9 Finally disconnect the jump lead between the (+)
terminals.
10 Re-install the battery pole stud protections.
Warming up
Machine may respond slowly at low temperatures.
Operate carefully until the system has reached
normal temperature. Otherwise unexpected
movements may occur.
Operating instructions
Starting engine
151
To Next Page
Loading...
