Delaying regeneration
The operator can delay the regeneration by
pressing the ESC button on the keypad when an
alarm indication for regeneration pops up on the I-
ECU. The alarm indication will pop up again after
15 minutes or when the engine is restarted.
Delayed regeneration may be useful if the machine
is in a heat-sensitive environment.
NOTE!
It is important not to delay regeneration
unnecessarily.
Possible consequences of delaying regeneration:
- engine derate.
- higher fuel consumption.
- shorter diesel particulate filter service life.
- damage to the aftertreatment system.
Cancelling dynamic or parked regeneration
NOTE!
Only cancel in an emergency.
1 Select the Stop menu on I-ECU. (Menu —>
Engine-> Regen start/stop —> Stop).
An alarm indication on the instrument panel
confirms that regeneration has been cancelled.
Regeneration is cancelled automatically when:
- a malfunction occurs
- machine operation starts and a parked
regeneration is in progress
- the machine is turned off
Regeneration cancelled
158
Operating instructions
Exhaust aftertreatment system
To Next Page
Loading...
