Tying down machine
NOTE!
Make sure that loading ramps and platforms are
free from oil, mud, ice and similar so that the
machine does not begin to slip.
1 Park the machine in the same position as shown
illustration.
2 Load the machine so that the bucket cylinder rod
does not contact the trailer.
3 Never operate any lever other than the travel
levers (pedals) while the machine is on the
loading ramp.
4 Stop the machine.
5 Remove the ignition switch.
6 Turn OFF the battery disconnect switch.
7 Lock the door and the access covers.
8 Secure the machine with tie downs of adequate
load rating so that the machine cannot move.
Tie-down points
170
Operating instructions
Transporting machine
To Next Page
Loading...
