Caution during hammer operation
NOTE!
Listen to the sound of the hammer when you are
using it. If the sound becomes weaker and the
impact less efficient, the tool is misaligned with the
material and/or there is not enough feed force on
the tool. Realign the tool and press the tool firmly
against the material.
Do not operate the cylinder to its end of stroke,
leave about 5cm.
Do not swing the hammer against the rocks,
concrete and so on.
Do not move the chisel while it is striking a blow.
Do not strike horizontally, or in an upward direction.
208
Operating techniques
Hammer
To Next Page
Loading...
