For Volvo tooth system (VTS)
Replace the bucket teeth before the adaptors wear
away.
WARNING
Risk of splinter injury.
Striking the bucket pin with a hammer could cause
metal chips to fly around and cause serious splinter
injury.
Always wear face and eye protection, hard hat and
gloves while removing and installing the bucket
pins.
A special tool may be ordered to facilitate
replacement of teeth. The tool are available in
different sizes depending on tooth size. Contact
your dealer for further information.
Removing tooth
1 Lower the bucket horizontally on a block and
angle it slightly upward.
2 Move the control lockout lever up to lock the
system securely and stop the engine.
3 Clean the opening for tooth adapter locking
device.
4 Knock out the locking device with a hammer and
the tool or other suitable drift.
5 Remove tooth.
Special tool
Knock out the locking device
Maintenance
Maintenance service, when required
289
To Next Page
Loading...
