NOTE!
When the delay time is shown, press and hold the
SELECT button to enter the owner code.
- There are 3 levels for authorizing machine
operation.
Level 1: This is the operator code with 4 digits
which are set by the machine owner in I-ECU
menu or CareTrack portal.
Level 2: This is a machine owner PIN code with
6 digits which are set using Volvo's service tool.
Level 3: This is a one-time code with 8 digits
which are obtained from the CareTrack portal.
Geofence broken
- When the machine owner activates a geofence in
the CareTrack portal and the machine is outside
the geofence, the geofence broken message will
appear on the I-ECU.
- When the machine owner activates a geofence
and configures automatic immobilization in the
CareTrack portal and the machine is outside the
geofence, the geofence broken warning message
will appear on the I-ECU and the machine is
immobilized at the next stop.
- WECU sends the warning message to the
CareTrack portal.
- The warning condition is revoked when the
machine is inside the geofence.
V1137932
0
Enter owner code:
Enter owner code
V1137933
Geofence broken
GO BACK TO SITE
V1137934
Geofence broken
Immobilization at next stop
Instrument panels
Display unit
77
To Next Page
Loading...
