Volvo EW160E - Page 147

M
Measures b efore and during operation
Walk around the machine and check that there are no
obstacles next to the machine.
Check that mirrors and other visibility-enhancing devices are
in good condition, clean, and correctly adjusted.
Clean the cameras (if installed) to always have a clear picture
on the screen.
N
O
O
T
T
E
E
!
!
Always use an appropriate ladder or an appropriate platform to
get access to the cameras for cleaning purposes.
Check that the horn, back-up/travel alarm and rotating warning
beacon (optional equipment) are working properly.
Always follow the rules and procedures established by the job
site organisation.
Always pay attention around the machine to identify any
obstacles.
Prevent persons from entering or remaining in the work area,
i.e. the area around the machine and at least 7 m (23 ft) beyond
the maximum reach of the attachment.
Some applications (e.g. Lifting operation) requires a person in
the vincity of the machine. Depending on the job site
organisation the operator may allow a person to remain in the
work area, but must then observe caution and operate the
machine only when the person is visible or has given clear
indications of where he or she is.
Never allow any person to walk or stand under raised
equipment or suspended loads.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
n
n
g
g i
n
n
s
st
r
r
u
u
c
ct
i
i
o
o
n
n
s
s
1
4
4
5
5