Controls
66 Hydraulic controls
2
Moldboard slide shift lever
This lever is the third lever in from the extreme left. It controls the
left-to-right sliding action of the moldboard.
n Push forward on the moldboard slide shift lever to slide the
blade out to the left-hand side of the grader.
n Pull back on the lever to slide the blade to the right-hand side
of the grader.
3
Circle turn lever
This lever is the fifth lever in from the extreme left. It controls the
clockwise and counterclockwise rotation of the circle and mold-
board assembly.
n Push forward on the circle turn lever to rotate the circle coun-
terclockwise.
n Pull back on the lever to rotate the circle clockwise.
WARNING!
Keep clear when engine is running or moldboard is off
ground.
To Next Page
