AUDIO AND MEDIA
* Option/accessory.
66
Voice recognition - quick
commands
Voice recognition (p. 63) can be carried out
using a number of predefined quick commands.
Quick commands for the multimedia system and
the phone can be found in the normal view for
MY CAR (p. 14) by pressing OK/MENU and then
selecting
Settings Voice control settings
Command list Global commands,
Phone commands, Media commands, Radio
commands
and Navigation commands*.
The help text for each command tells whether
the command can be used in all sources or if it
can only be used in one source.
Voice recognition - mobile phone
Voice control (p. 63) a Bluetooth
®
-connected
mobile phone to e.g. call a contact or dial a num-
ber.
The following dialogues are only examples; the
system's response may vary depending on the
situation.
Dial a number
The system understands the numbers 0 (zero) to
9 (nine). These numbers can be pronounced
individually, in groups of several numbers at a
time or whole numbers all at once. Numbers
greater than 9 (nine) cannot be handled by the
system; for example, it is not possible to use 10
(ten) or 11 (eleven).
The following dialogue with voice commands
dials a number.
1.
The user starts the dialogue by saying: "
Dial
number".
>
The system responds with: "
Say the
number".
2. Start saying the numbers (as individual units,
i.e. "
Six-eight-seven" etc.) in the phone
number.
> At the pause, the system will repeat the
last spoken group of numbers.
3. Continue to say the numbers. When the
whole number has been spoken, end by say-
ing: "
OK".
> The system dials the number.
The number can be changed the number by say-
ing "
Correct" (which deletes the last spoken
group of numbers) or "Erase" (which deletes the
whole spoken phone number). By saying
"Repeat" the system will read out the whole
spoken number.
Call a contact
The following dialogue with voice commands
calls a contact in the phone book.
1.
The user starts the dialogue by saying: "
Call
contact".
>
The system responds with: "
Say the
name".
2. Say the name of the contact.
> If only one contact is found then the sys-
tem calls the contact, otherwise the sys-
tem continues to give instructions for find-
ing the right contact.
If a contact has multiple numbers entered in the
phone book then it is possible to say, for exam-
ple, "
Mobile" or "Work" after the name in order
to help the system.
More commands
More commands for voice recognition control of
a mobile phone can be found in the normal view
To Next Page
Loading...