INSTRUMENTS AND CONTROLS
* Option/accessory, for more information, see Introduction.
110
Magnetic zones.
4. Press the button repeatedly until the
required magnetic zone (
1–15) is shown.
See the map of magnetic zones for the com-
pass.
5. Wait until the display returns to showing the
character C, or hold the button on the under-
side of the rearview mirror depressed for
approx. 6 seconds until the character C is
shown.
6. Drive slowly in a circle at a speed of no more
than 10 km/h (6 mph) until a compass direc-
tion is shown in the display, indicating that
calibration is complete. Then drive a further 2
circles to fine-tune calibration.
7.
Cars with heated windscreen*: If the char-
acter
C is shown in the display when the
heated windscreen is activated, perform the
calibration in accordance with point 6 above
with the heated windscreen activated, see
Demisting and defrosting the windscreen
(p. 134).
8. Repeat the above procedure as necessary.
Sunroof*
The sunroof can be operated with a control in
the roof panel.
The sunroof's inner sunscreen is closed man-
ually.
The sunroof has a wind deflector.
The sunroof controls are located in the roof
panel. The sunroof can be opened vertically at
the rear edge and horizontally. Key position I or II
is required for the sunroof to be opened.
Horizontal opening
To Next Page