WHEELS AND TYRES
* Option/accessory, for more information, see Introduction.
329
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tightened
properly. Tighten to 140 Nm. Check the tor-
que with a torque wrench.
5. Refit the plastic caps on the wheel bolts.
The white arrow must point toward the front of the car.
6. Screw apart the towing eye and the wheel
bolt wrench. Place the wheel bolt wrench
and the jack in their respective compart-
ments in the bag. Tighten the bag's centre
strap firmly and use the other strap to secure
the bag in the rear load retaining eyelet on
the left-hand side of the cargo area. Position
the bag so it is not pinched when the tailgate
is closed. The white arrow on the bag must
point toward the front of the car.
NOTE
•
After a tyre has been inflated, always refit
the dust cap in order to avoid damage to
the valve from gravel, dirt, etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
WARNING
The bag should be secured so that the white
arrow (see the inset figure) points forward in
the car.
When changing to another tyre
dimension
Contact an authorised Volvo workshop for updat-
ing the software at each change of tyre dimen-
sion. A software download may be necessary
both when changing to larger and smaller dimen-
sions, and also when switching between summer
and winter wheels.
Related information
•
Changing wheels - removing wheels (p. 326)
•
Jack* (p. 331)
•
Warning triangle (p. 330)
•
Wheel bolts (p. 325)
To Next Page
Loading...
