||
LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory.
614
4.
Insert the supplied screw and tighten using
the supplied 6 mm Allen key. Repeat on the
other side. Recommended tightening torque:
20 Nm (15 foot-pounds).
> Check that the safety grille is properly fit-
ted.
5. Restore the backrest to the upright position.
For more information about the tools required
and methods for fitting/removal, see the installa-
tion instructions
4
that were included with the ini-
tial purchase.
IMPORTANT
The protective grille cannot be folded up or
down when a cargo cover is fitted.
Related information
•
Recommendations for loading (p. 607)
•
Load retaining eyelets (p. 610)
Fitting and removing the safety net*
The safety net prevents loads from being thrown
forward in the passenger compartment in the
event of sudden braking.
The safety net is fitted into four mounting points.
For reasons of safety, the safety net must always
be fastened and anchored as described below.
The net is made of a strong nylon fabric and can
be secured two different locations in the car:
•
Rear fitting - behind the rear seat.
•
Front fitting - behind the front seats.
4
Installation instructions no. 31659257.
To Next Page
Loading...
