Vornado ELEMENT S - Page 20

19
English
CLEANING THE BASE
1. Turn humidier off and unplug.
Note: Be sure you are near a sink or an area that will not be damaged by water. Excess water will ush
from heat element cover when disassembling.
2. Disassemble humidier:
– Remove water tank rst.
– Remove power head by pushing in on the tab and
lifting up. The tab is located on the right side of
the housing where it meets the base.
– Remove all silicone parts. WARNING: Do not
grasp outlet grill while removing power head,
it may be hot.
3. Clean base and silicone parts with warm water and a
mild detergent. Rinse and dry.
4. Reassemble humidier:
– Ensure the silicone parts are back in place.
WARNING: Do not run humidier without the silicone parts.
– Position power head so it is aligned with the base. Insert the tab into the slot in the base until it
latches.
– Replace water tank and resume operation.
Tab