Vornado ELEMENT S - Getting Started Guide; Initial Setup and Leak Check Procedures

6 English
Before operating, ALWAYS lift from the bottom by using the handles located on the base. Lifting
the water tank handle on the water tank will cause the tank to detach from the humidier.
Check appliance for visible damage. DO NOT USE if there is evidence of damage. If any damage
is found, contact Vornado Air, LLC at 1-800-234-0604.
CAUTION: When removing water tank lift vertically, do not twist tank while still in base or cap
may disengage and leak.
WARNING: To avoid overlling the base, remove the water tank before the power head to
avoid water displacement.
GETTING STARTED
CHECK FOR LEAKS
Damage due to shipping may cause leaks in base or water tank. A visual
inspection may not reveal hairline fractures.
1. Place humidier on a water-resistant
surface.
2. Fill water tank with water to inspect
for leaks.
3. Pour several cups of water into base to
inspect for leaks.
Not Leaking?
Empty water from base and install full
water tank.
Leaking?
In the slight chance your humidier has
leaks, contact Consumer Service and we
will immediately replace damaged parts.
Note: Be gentle handling water tank when relling to prevent any damage.