13
English
TROUBLESHOOTING
POSSIBLE CAUSE AND SOLUTIONPROBLEM
Unit is not plugged in. Plug Power Cord into electrical outlet.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT SAFETY INSTRUCTIONS for how to replace the fuse or
contact Consumer Service.
Ensure unit is set to highest setting for maximum air circulation.
Allow the unit to fully circulate the air throughout the room, this may take several minutes.
Ensure all air inlets and outlet grille are unobstructed.
The battery is dead. Replace with new 3 volt CR2032 battery. Refer to REMOTE CONTROL - Battery
Replacement for instructions.
The remote needs a line of sight to allow the unit to receive the signal. Position the unit so that the
receiving lens, located below the grey “V” logo, is visible from the remote control.
Unit fails to
power on.
Unit is not producing
sufcient amount of air.
Remote Control is not
working.
To Next Page
Loading...
