10 English
1. Press to power on.
2. Select desired speed setting by pressing -/+ button.
FAN SPEED -/+
POWER
REMOTE CONTROL
REMOTE FUNCTIONS BATTERY REPLACEMENT
1. For battery replacement, the remote requires one coin style 3V
CR2032 battery. Always use the correct size and grade of battery for
this product.
2. To replace battery, open battery door on the back side of the
remote control (you will need to loosen the small screw on door
using a #1 Phillips screwdriver). If necessary, clean the battery
contacts and also those of the device prior to battery installation.
Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is
installed correctly with regard to polarity. Replace the battery door
and screw.
Note: Remove battery from the remote control when not in use for an
extended period of time and always remove dead battery immediately
and replace with fresh. Do not store dead battery in remote.
Your circulator remote includes (1) coin style 3V CR2032 battery. Bat-
tery comes pre-installed. Remove battery pull tab before fi rst use.
Note: The remote requires a line-of-sight path to allow for the signal
to be received by the product. Position the product so the receiver
lens (located at the top of the grille) is visible from the remote control.
35
Français
RÉGLAGE DE VITESSE
MARCHE/ARRÊT
1. Appuyez sur pour mettre l’appareil sous tension.
2. Appuyez sur pour choisir la vitesse désirée: Haute,
Moyen-élevé, Moyen, Faible
3. Appuyez sur pour mettre l’appareil sous éteindre.
UTILISATION
To Next Page
Loading...
