Need help?Do you have a question about the VORON 2.4 and is the answer not in the manual?
General| Build Volume | 350 x 350 x 350 mm |
|---|---|
| Extruder Type | Direct Drive |
| Heated Bed | Yes |
| Frame Material | Aluminum |
| Filament Diameter | 1.75 mm |
| Motion System | CoreXY |
| Firmware | Klipper |
| Print Technology | FDM |
| Max Nozzle Temperature | 300°C |
| Max Bed Temperature | 120°C |
| Power Supply | 24V |
| Enclosure | Optional |
| Weight | Approx. 20 kg |
| Layer Resolution | 0.05mm - 0.3mm (depending on nozzle and settings) |
| Connectivity | USB |
| Nozzle Diameter | 0.4 mm |
| Bed Leveling | Automatic |
| Controller Board | SKR 1.3 or 1.4 |
| Z-axis | Triple Z-axis motors with leadscrews |
To Next Page
