Need help?Do you have a question about the VORON 2 and is the answer not in the manual?
General| Filament Diameter | 1.75mm |
|---|---|
| Max Nozzle Temperature | 300°C |
| Max Bed Temperature | 120°C |
| Motion System | CoreXY |
| Layer Resolution | 0.05 - 0.3 mm |
| Nozzle Diameter | 0.4mm (standard) |
| Frame Material | Aluminum extrusion |
| Firmware | Klipper |
| Bed Material | Aluminum |
| Extruder Type | Direct drive or Bowden |
| Power Supply | 24V power supply |
| Build Volume | 250x250x250 mm (standard) |
| Controller Board | Customizable (commonly RAMPS, RAMBo, Duet, etc.) |
Specifies naming conventions for 3D printed parts.
Outlines recommended settings for 3D printing components.
Highlights critical steps requiring special attention during assembly.
Details the specific fasteners and parts used in the manual.
Provides helpful advice and general guidance for the build process.
Assembly instructions for the A driveshaft component.
Assembly instructions for the B driveshaft component.
Assembly of one type of cable chain link for the printer.
Assembly of another type of cable chain link for the printer.
To Next Page
