VORON 2 - File Key and Part Printing Guidelines; File Key; Part Printing Guidelines

2
V1.0.0
File Key / Part Printing Guidelines and Standards
Part Printing Guidelines and Standards
Approved FDM Materials
ABS or ABS+ Only
Layer Height
0.2mm
Extrusion Width
Forced 0.4mm
Infill Percentage
40% minimum
Infill Type
Grid, Gyroid, Honeycomb, Triangle or Cubic
Wall Count
4 minimum
Solid Top/Bottom Layers
5 minimum
File Key
Primary Color
nothing at start of file name
Accent Color
[a]_ at start of file name
Quantity Required
_x# near end of file name
File Revision
_Rev# at end of file name