Need help?Do you have a question about the VORON ERCF v2 and is the answer not in the manual?
Essential guidelines for successful 3D printing of ERCF parts.
Understanding the naming system for STL files used in the build.
Detailed list and descriptions of hardware fasteners and magnets.
Listing essential and recommended tools for the ERCF build.
Introduction to the Enraged Rabbit Project and its components.
Recognition of contributors to the ERCF project.
Guidance on obtaining assistance and resources for the build.
Concluding remarks and encouragement for the build process.
How to use the calibration tool to ensure printer accuracy.
Comprehensive guide on using heat set inserts for the build.
Instructions on how to use the provided CAD files for reference.
Information on reusing parts when upgrading from previous ERCF versions.
Connecting the ERCF to a remote MCU, including wire length charts.
Wiring the ERCF using a local MCU or buddy board.
Instructions for connecting and wiring the ERCF's LED status indicators.
Visual overview and exploded view of the gearbox assembly.
Steps for preparing gearbox parts and assembling the latch mechanism.
Assembling the drive shaft, gears, and belt tensioning.
Mounting motors, integrating panels, and cable management.
Closing the gearbox, adding knob/logo, and final belt tensioning.
Introduction to filament blocks and their exploded view.
Cleaning prints, assembling bases, paths, and top hats.
Assembling multiple filament blocks into an array and aligning them.
Bondtech gear alignment and top hat clearance adjustments.
Visual overview and exploded view of the selector mechanism.
Preparing the selector cart, inserting bearings, and heat set inserts.
Mounting the servo, installing the spring, and managing servo wires.
Adjusting tension screws, installing drag chain anchor.
Exploded view and Bill of Materials for the encoder.
Preparing the encoder wheel and assembling the main encoder housing.
Installing the completed encoder onto the selector assembly.
Overview and exploded views of the linear axis assembly.
Mounting the motor, idler block, and assembling the axis.
Installing and tensioning the drive belt for the linear axis.
Overview and exploded view of the fully assembled ERCF.
Instructions for adding nuts, joining blocks, idler adjustment, and belt tensioning.
Final wiring, drag chain setup, and securing all cables.
Introduction to the Cottontail build guide and overview.
Assembling arm groups, coupler blocks, and endcap arms.
Covers arm prep, axle/wheel, wiring, electronics box, and tube management.
General| Brand | VORON |
|---|---|
| Model | ERCF v2 |
| Category | 3D Printers |
| Language | English |
To Next Page
