WWW.VORONDESIGN.COM
CAD version: ERCF V2
4
PART PRINTING GUIDELINES
The Voron Team has provided the following print guidelines for you to follow in order to have the best chance at success with
your parts. There are often questions about substituting materials or changing printing standards, but we recommend you
follow these.
4
INTRODUCTION
FDM MATERIAL
The ERCF was tested only with ABS, so I
recommend to use ABS to build the ERCF.
INFILL TYPE
Grid, Gyroid, Honeycomb, Triangle or Cubic.
MATERIAL
The ERCF was tested only with ABS, so I
recommend to use ABS to build th
INFILL PERCENTAGE
Recommended: 40%
LAYER HEIGHT
Recommended : 0.2mm
WALL COUNT
Recommended : 4
EXTRUSION WIDTH
Recommended : Forced 0.4mm
SOLID TOP/BOTTOM LAYERS
Recommended : 5
Beware that this project requires a well tuned printer and slicing profile, as there are many press fits and plastic on plastic
mechanisms. You should first print the ERCF_Calibration_Tool.stl, test the part, as shown in the manual, tune your printer and
profile if needed, and then only print the rest of the parts.
PRINT GUIDELINES
To Next Page
Loading...
