WWW.VORONDESIGN.COM
CAD version: ERCF V2
88
INTRODUCTION
TOOLS
BALL-END DRIVER
Some parts of this design require the use of a
ball-end hex driver for assembly. We recommend
you get a 2.0mm, 2.5mm and 3mm one.
2.5MM HEX DRIVER
The 2.5mm hex driver will see a lot of use in this
build. A quality driver is strongly recommended.
Refer to the sourcing guide for suggestions.
ADDITIONAL TOOLS
We provide additional tool recommendations in
our sourcing guide. Visit https://vorondesign.com/
sourcing_guide and switch to the “Voron Tools”
tab at the bottom of the page.
To Next Page
Loading...
