VORON ERCF v2 - Upgrading from ERCFv1

WWW.VORONDESIGN.COM
CAD version: ERCF V2
17
If you are upgrading from ERCFv1 or v1.1, you can re-use some of the printed parts. These parts will have a dagger † every
time we mention the file name, in case you want to re-use those parts. Here is a list:
17
INTRODUCTION
UPGRADING FROM ERCFv1
ERCF_v2 / STLs / Gear_Box
[a]_Bearing_Spacer_x2.stl †
[a]_Knob.stl †
[a]_Logo_Plate.stl †
[a]_M4_80T_Wheel.stl †
[a]_Side_Latch_x2.stl †
[mm]_Voron_Logo_Plate.stl †
Motor_Arm_NEMA14.stl †
Motor_Arm_NEMA14_EASYBRD.stl †
Motor_Arm_NEMA17.stl †
Motor_Arm_NEMA17_EASYBRD.stl †
ERCF_v2 / STLs / Linear_Axis
[a]_Drag_Chain_Anchor_Bottom.stl †
[a]_Motor_Lock.stl †
ERCF_v2 / STLs / Selector
Belt_Tensioner.stl †
Drag_Chain_Anchor.stl †
ERCF_v2 / STLs / Supports / Adjustable_Mount
[a]_Screw_x3.stl †
Junction_Plate_Flat_x2.stl †
Junction_Plate_Gear_Box.stl †
ERCF_v2 / STLs / Supports / Adjustable_Mount / 2020
2020_Mount.stl †
2020_Mount_Mirrored.stl †
ERCF_v2 / STLs / Supports / Adjustable_Mount /
3030_(SW_with_panels)
3030_Flat_Mount.stl †
3030_Flat_Mount_Mirrored.stl †
ERCF_v2 / STLs / Supports / Adjustable_Mount /
3030_(SW_without_panels)
3030_Mount.stl †
3030_Mount_Mirrored.stl †
ERCF_v2 / STLs / Supports / Adjustable_Mount / Option
ERCF_Easy_Brd_Bracket_Mount.stl †
ERCF_v2 / STLs / Supports / V1_V2
[a]_Support_Feet_4mm_x4.stl †
[a]_Support_Feet_5mm_x4.stl †
ERCF_v2 / STLs / Tools
Pulley_Tool_NEMA14.stl †
Pulley_Tool_NEMA17.stl †