WWW.VORONDESIGN.COM
CAD version: ERCF V2
CLOSING THE GEARBOX
Install the Motor_Arm and pass the belt around the
GT2 pulley of the Gear Motor, but don’t tension it yet.
Carefully insert and tighten the M3x25mm screw
first, and then the M3x12mm screw. Take your time.
Make sure no wires are pinched between parts.
4545
GEARBOX
M3x12 SHCS
M3x25 SHCS
CLOSING THE GEARBOX
CABLE MANAGEMENT
Make sure the wires are routed in the channel
between the 2020 extrusion and the Gear_Box_Back.
If you route the wires through the other opening, you
won’t be able to connect the wires later!
To Next Page
Loading...
