WWW.VORONDESIGN.COM
CAD version: ERCF V2
5555
FILAMENT BLOCKS
PRINT IN PLACE SUPPORTS
Before you begin you will need to remove all the print in place and built
in supports for the Filament Block parts using a small screwdriver.
Please take care that you don’t accidentally damage the part or yourself
especially the Tophat and the upper Bondtech idler pin mount.
Repeat for all of the Bases, Filament_Paths, and Tophats.
Remove
Remove
Filament_Path_xN
Base_xN
Tophat_xN
Remove
PREPARATION
To Next Page
Loading...
