WWW.VORONDESIGN.COM
CAD version: ERCF V2
5656
FILAMENT BLOCKS
PRINT IN PLACE SUPPORT CLEANUP
Ideally, the print in place supports will snap cleanly out of the parts. If
this is the case for you, congratulations! Your print settings are very
dialed-in.
Otherwise, please clean up the highlighted surfaces with a small file or
hobby knife. Make sure that the print in place supports didn’t leave any
stuck bits behind and interfere.
Repeat for all of the Bases, Filament_Paths, and Tophats.
Filament_Path_xN
Base_xN
Tophat_xN
PREPARATION
To Next Page
Loading...
