WWW.VORONDESIGN.COM
CAD version: ERCF V2
11
This is the place to recognize the origins and evolution of this project. ERCF was originally envisioned and created by Ette and
the v1.1 release credits Tircown, the Voron Dev team (special mention to Dunar), Benoit, Dustin Speed, Kageurufu and the
HonHonHonBaguette people!
Over time and significant adoption the shortcomings of ERCF v1.1 design came to light, and that inspired a set of
modifications to address them: SturdyBunny, TripleDecky, Springy, Binky and other strange names appeared. It was then that
Moggieuk, the author of Happy Hare, rounded up these project authors and created the beginnings of the ERCF v2
community release. As the project developed, Kinematicdigit developed and contributed CottonTail, Sorted developed and
contributed Filametrix and we were joined by some awesome talent that polished, tested and documented to complete the
project.
Many hundreds of hours of volunteer effort have gone into this project and we hope it pays tribute to Ette’s wonderful original
design. The BMW of MMU’s!
● @moggieuk V0.1503 | V2.4088 (Happy Hare Dev & Chief whip)
● @gneu V2.5345 (Filament block and bling innovator)
● @sneakytreesnake V2.3804 (The project backbone!)
● @mneuhaus VT.483 (Binky Dev)
● @Miriax (Designer & Doc Demon)
● @kinematicdigit (Cottontail Dev & Doc Illustrator)
● @ningpj (Tester, Breaker & Doc's)
● @fizzy (King of CAD)
● @gsx8299 (Test Builder Extraordinaire)
● @sorted (Filametrix "don't get enraged" filament cutting system Dev)
● @kierantheman (Thumper Dev)
👏 👏 👏
11
INTRODUCTION
ACKNOWLEDGEMENTS
To Next Page
Loading...
