WWW.VORONDESIGN.COM
CAD version: ERCF V2
9595
SELECTOR : ENCODER
INSTALL ENCODER WHEEL
Before fitting the Encoder_Slotted_Wheel to the
Bondtech gear, make sure the top surface of the
wheel and its vanes are smooth and clean. If
there are “blobs” from printing, carefully sand or
trim them so they are flush.
Place the Bondtech gear as shown in the
diagram on a hard surface and slide the
Encoder_Slotted_Wheel onto the gear until it
reaches the teeth.
Use the Slotted_Wheel_Push_Tool to gently
push the Encoder_Slotted_Wheel into place
until it is flush with the end of the gear using a
small hammer.
The Encoder_Slotted_Wheel should fit firmly on
the Bondtech gear. Make sure its undamaged,
isn’t cracked and doesn’t move easily.
NOTE The Encoder_Slotted_Wheel must be
printed in black to prevent light shining
through the vanes of the wheel to avoid false
readings!
ENCODER PREPARATION
Slotted_Wheel_Push_Tool
Encoder_Slotted_Wheel
BMG Idler Gear
To Next Page
Loading...
