Vortex ANARCH - Menu Selections; Changing Menu Settings

8 9
™
MENU SELECTIONS
Changing Menu Settings
The Anarch
™
is factory set to Slope Mode on, PinSpotter
™
Mode on, Circle reticle, and yards. To change settings,
press and release the “Measure” button to power the
unit on. Press and hold the “Menu” button until the
Menu screen appears (about two seconds). Scroll through
the settings options by clicking the “Menu” button. To
adjust a setting, click the “Measure” button. To save your
settings and exit the Menu, press and hold the “Menu”
button for at least two seconds.
Use the “Menu” button to activate the
Menu Selections and scroll through
the options.
Use the “Measure” button to adjust
the mode.
Low Battery Icon
The Low Battery Icon displays
once the battery reaches 25%
life and stays on until there is no
power or the battery is replaced.
Focus
Adjust the Diopter until the image
is sharp and the reticle is in focus.
Make note of this Diopter setting
in case you need to set it again.
Low Battery