16 17
™
Scan Feature
Activate the Scan Feature
by pressing and holding the
“Measure” button. Keeping
the button depressed will
continuously measure as you
pan back and forth cross
the target objects. “Scan”
will illuminate in the upper
left-hand corner of the display
while scanning.
Scanning to get range:
Scan back and forth, watching for yardage number to display or change.
Note: The broken circle segments around the reticle will flash
while scanning.
Ranging
The Anarch
™
features image stabilization which eliminates
shake for a clear sight picture and easy ranging. To range,
position the reticle on the target object you wish to range,
then press and release the “Measure” button to get the
distance measurement. If the laser is not able to range
due to the target object’s reflectivity or being too close,
you will see a display similar to that shown here. To range
a new target, simply re-aim and press the “Measure”
button again.
Range Returned No Range Returned
To Next Page
Loading...
Need help?
General
