To Next Page

To Previous Page

IntroductionPanel TourSetupPlayingCreating

and Storing

1.9 REVERB selector

This selects one of eleven reverb effect models. When you turn the REVERB

selector, the REVERB select button will blink, and you can use value knobs 1–

6 to adjust the parameters of the reverb effect. (For details on each effect, refer

to p.48–.)

NOTE: The parameters will be initialized when you switch effect types.

EDIT SECTION

2.1 Edit category LEDs

One of the LEDs will blink to indicate the category of effect you are currently

editing.

When adjusting the parameters, an LED will blink to indicate the line of param-

eter names that you are adjusting.

2.2 Value knobs 1–6

Use these to adjust the parameters of the effects or amp model. Your adjust-

ments will modify the effect whose MODEL select button you pressed (i.e., the

button that is blinking). The LEDs below the knobs will light to indicate the

knobs that are available.

For details on the parameter controlled by each knob, refer to p.35–. (From the

left, we refer to these as value knobs 1–6.)

When the EXPRESSION button or CONTROL button is blinking, these knobs

adjust the corresponding functions.

When you are making RENAME or GLOBAL settings, or when executing the

WRITE operation, you can use value knob 6 to change values.

Other manuals for Vox Valvetronix ToneLab SE

Questions and Answers:

Need help?

Do you have a question about the Vox Valvetronix ToneLab SE and is the answer not in the manual?

General