To Next Page

To Previous Page

5. Slowly advance the expression pedal 1 away from yourself (pedal forward),

and take your hand off the pedal when it stops.

NOTE: If you decide to cancel the calibration procedure,

press the EXIT button.

6. Press the GLOBAL button.

The name display will indicate COMPLETE for one second, and then

ToneLabSE will return to normal operation.

If the sensitivity could not be adjusted correctly, the name display will indicate

ERROR, and will then indicate EXP1 MIN. Repeat the procedure from step 3.

NOTE: If you are still unable to adjust the sensitivity after repeated attempts, it is

possible that ToneLabSE has malfunctioned. Please contact your dealer or Vox

authorized service center.

EXPRESSION PEDAL 2

1. Turn the power OFF.

2. While holding down the CONTROL button and the CHAIN button, turn the

power on. The name display indicates EXP2 MIN. Perform steps 3–6 as

described above to adjust the sensitivity of expression pedal 2.

NOTE: If you are still unable to adjust the sensitivity after repeated attempts, it is

possible that ToneLabSE has malfunctioned. Please contact your dealer or Vox

authorized service center.

Other manuals for Vox Valvetronix ToneLab SE

Questions and Answers:

Need help?

Do you have a question about the Vox Valvetronix ToneLab SE and is the answer not in the manual?

General