64
Restoring the Factory Preset
Programs
ere’s how you can restore ToneLabSE’s programs and all its other settings
to the state in which it was shipped from the factory.
NOTE: Executing this procedure will erase all the programs you created and saved
in ToneLabSE, and will load the factory-set programs. MIDI settings will also be ini-
tialized. If there are any settings you want to keep, you should first use the data
dump function to back them up, or use the “Program sheet” (the fold-out inside the
back cover of this manual) to write down your settings.
1. While holding down the three buttons ▲, ▼ (3.1), and EXIT switch (3.7), press
the STANDBY button to turn on the power.
The bank display (5.1) “P” and the LED 1–4 buttons (6.2) will blink, and the
name display (3.8) will ask “RELOAD?” Release the three buttons you were
holding down.
2. If at this point you decide that you really don’t want to execute this operation,
you can press the EXIT switch.
3. Press the WRITE button (3.6). The name display (3.8) will show “LOADING,”
and the factory-set data will begin being reloaded.
When reloading has been completed, the name display will indicate “COM-
PLETE,” and ToneLabSE will automatically switch to Program Select Mode.
NOTE: Never turn off the power while this reload operation is occurring.
H
To Next Page
Loading...
Need help?
General
