40
OTB CALL TO A sINGLE DEVICE
1. There are a few ways to begin a OTB call to a single
device. When the handset is not in use:
If you have two handsets, press and hold OTB.
If you have more than two handsets:
w Press OTB on the handset, then use the dialing
keys to enter the destination handset number.
-OR-
w Press OTB on the handset. Press
or to
highlight the destination handset number,
then press SELECT or OTB.
The handset shows Connecting to VTECH X...
(
VTECH
represents the handset name, X represents
the destination handset number)
for a few seconds.
When the connection is made, both your and the
destination handset screens display Press and hold
[OTB] to talk.
2. Press and hold OTB. A chirp indicates your microphone
is on. Speak towards the device. Your voice is
broadcast to the destination handset. While you are
speaking, your handset shows OTB To
VTECH
X.
3. Release OTB after speaking. Both devices beep once
again and the screens show Press and hold [OTB]
to talk, then you can press and hold OTB to continue
speaking or the destination device can respond.
4. To end the OTB call, press OFF/CANCEL or END, or
place the handset in the charger. The handset shows
Broadcast Ended.
•
•