8
Option 2: Use this method so that you can relocate the baby unit with
the wall mount bracket easily.
Note
Check for reception strength and camera angle before drilling the holes.
Place the wall mount bracket on a wall and then use a pencil to mark
the top and the bottom holes as shown. Then remove the wall mount
bracket and drill two holes in the wall. Check for reception strength
and camera angle before drilling the holes.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer
until the wall anchors are flush with the wall.
1.
2.
To Next Page
Loading...
